Jump to content

Scripting AI JTAC to use parameters for CAS?


WildBillKelsoe
 Share

Recommended Posts

I want to know if there is any way I can script AI JTAC to attack 3 different targets using the radio interface. What I want to do is to assign a tank as target 1, truck as target 2, infantry as target 3, and direct A-10's to attack

as follows (for example):

 

1- IP set

2- attack headings

3- attack weapon

4- egress heading

5- BDA auto report

AWAITING ED NEW DAMAGE MODEL IMPLEMENTATION FOR WW2 BIRDS

 

Fat T is above, thin T is below. Long T is faster, Short T is slower. Open triangle is AWACS, closed triangle is your own sensors. Double dash is friendly, Single dash is enemy. Circle is friendly. Strobe is jammer. Strobe to dash is under 35 km. HDD is 7 times range key. Radar to 160 km, IRST to 10 km. Stay low, but never slow.

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...