Jump to content

TARGET Software and DCS Fleet


doright
 Share

Recommended Posts

No. It can be setup to tie profiles to executables but since all modules run under the same exe Target cannot tell the difference.

ASUS ROG Maximus VIII Hero, i7-6700K, Noctua NH-D14 Cooler, Crucial 32GB DDR4 2133, Samsung 950 Pro NVMe 256GB, Samsung EVO 250GB & 500GB SSD, 2TB Caviar Black, Zotac GTX 1080 AMP! Extreme 8GB, Corsair HX1000i, Phillips BDM4065UC 40" 4k monitor, VX2258 TouchScreen, TIR 5 w/ProClip, TM Warthog, VKB Gladiator Pro, Saitek X56, et. al., MFG Crosswind Pedals #1199, VolairSim Pit, Rift CV1 :thumbup:

Link to comment
Share on other sites

  • 3 weeks later...

Next best thing is being able to change button assignments on the fly from within the profile. This is possible with TARGET, and you can set it to remap keys to the aircraft of your choice with a button combination.

 

Best bet is to create a separate TMC profile for each aircraft, then have a single master profile that has an include statement for each other aircraft TMC. Then in each separate TMC have a routine to assign the buttons, and then any aircraft-specific routines. Finally, have a subroutine in the master file to switch profiles at the button press of your choice (I use TEMPO with a shifted press of a MFD button and a time threshold of 2000 so there's no inadvertent switching).

 

I'd provide a code sample, but it's much too involved. Hopefully my profile will be released in beta state shortly.

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...