Jump to content

Upgraded Shapeoko Desktop CNC Router


jrsteensen
 Share

Recommended Posts

400mmx375mm footprint, will come partially assembled. (I'll pop the rails for packaging purposes)

 

  • 1/4" Stainless Steel Endplates, Motor Mounts and Z axis - Use to infinitely expand it! I had these water jetted to help take some flex out of the thin endplates, with plans to expand it. Use MakerSlide from Inventables to expand the Y axis (https://www.inventables.com/technologies/makerslide) and , and 40/20 extrusion to expand the X axis (https://www.inventables.com/technologies/aluminum-extrusion).
  • Dual Drive Y axis - allows for less slop on the Y Axis.
  • Upgraded X and Y axis to NEMA 23 motors for light aluminum milling. (Z axis is stock NEMA 17.)
  • DeWalt 660 Trim Router, with original Dremel mounts included.
  • 5 Axis CNC Controller (requires a PC Parallel port and Mach3.)
  • 12V 16A Power Supply

Use for engraving panels, light milling or PCBs, wood, plastic, light aluminum

You will only have to source wire and wire it up, and grab a couple 1/8 or 1/4" shaft mills from ebay. (I hadn't finished the wiring, but it is simple.)

I am asking $999.99 + Actual Shipping. I will accept Paypal (Either as a gift, or +4%). Will ship as two boxes.

IMGP6035.jpg~original

IMGP6036.jpg~original

IMGP6037.jpg~original

IMGP6038.jpg~original

IMGP6040-1.jpg~original

Link to comment
Share on other sites

  • 4 weeks later...
  • 2 weeks later...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...