Jump to content

During JHMCS X/Y axis alignment, moving TDC vertically and the cross will move to the other direction


Dr. Anti-Vehicle
 Share

Recommended Posts

Towards the end of the track, I moved TDC in the sequence of left, right, up, and down. But the cross went left, right, down, and up.

This behavior started since the last few patches. It's worth to mention that previously during roll alignment, moving TDC would also make bottom cross swing to the opposite direction, but this behavior was reversed and now it will follow TDC direction, which makes logical sense.

 

So if anyone can try this and clarify a bit, that will be greatly appreciated.

JHMCS TDC.trk

Link to comment
Share on other sites

  • 2 weeks later...
  • 3 weeks later...

Same here. Fine alignment UP and DOWN are reversed - Warthog.

  • Like 1

ROG Z690 Hero ● i9-12900K 5.5GHz ● Giggy RTX 3090 OC ● 32GB 4800MHz ● Firecuda M.2s ● Reverb G2 ● Win11Pro //// A10CII ● AH64D ● AJS37 ● AV8BNA ● C101 ● CEII ● F16C ● F5EII ● F86F ● FA18C ● FC3 ● I16 ● KA50 ● M2000C ● MI8 ● P47D ● SA342 ● SPIT ● UH1H ● Y52

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...