toby23 Posted September 14, 2021 Share Posted September 14, 2021 (edited) This is most likely my mistake but while doing the F/A-18C training on HSI and Tacan, the Tacan station info does not show on the HUD when the voiceover says it should. I see the TACAN and bearing and range info on the LDDI HSI page and I have the Tacan tuned correctly, I just don't see any info on the HUD. I also don't see a BOX around the word TCN when I select it. Any ideas? One more question - if I use HDG select to mark the TACAN marker on the HSI, why does the HEADING BUG move faster than the TACAN station. I would have thought they should both move at the same speed if I am turning towards them? Edited September 14, 2021 by toby23 Ryzen 5800X, 32GB RAM, RTX 3060 Link to comment Share on other sites More sharing options...
Solution Hulkbust44 Posted September 14, 2021 Solution Share Posted September 14, 2021 You need to select TACAN as the navigation source via the HSI. Top left, click TCN.Mobius708 Link to comment Share on other sites More sharing options...
toby23 Posted September 14, 2021 Author Share Posted September 14, 2021 When I click it, nothing happens. I don't see the box around TCN, which I think I should right? Ryzen 5800X, 32GB RAM, RTX 3060 Link to comment Share on other sites More sharing options...
toby23 Posted September 14, 2021 Author Share Posted September 14, 2021 (edited) I just checked again, thanks for your help. It wasn't showing because TCN wasn't boxed. I think it might have something to do with the training/ voiceover etc not recognising/ allowing it. Not sure but once the trainer had stopped speaking and given me control of the aircraft, I selected TCN and it BOXED and I could see the abbreviation and distance and steerpoint marker on the HUD. Thanks for your help. Much appreciated. Edited September 14, 2021 by toby23 Ryzen 5800X, 32GB RAM, RTX 3060 Link to comment Share on other sites More sharing options...
Recommended Posts