Jump to content

Behaviour for PRF / ACM / ACM Exit not clear


Recommended Posts

Posted (edited)

Procedure 1:

- Select GUN, note that ACM mode is activated and PRF toggles to MED

- Select AMRAAM, note that ACM mode is deactivated and PRF mode toggles to INT

 

Procedure 2

- Select BST (I don't tested different ACM modes) , note that ACM mode is activated and PRF toggles to MED

- Press PB7 to exit ACM, note that PRF mode keeps in MED

 

No question it makes sence to toggle to MED for ACM, but when exiting ACM the behavoiur should be the same in both cases.

 

grafik.png

PRF_ACM_BEHAVIOUR.trk


Edited by Topper81
Link to post
Share on other sites
  • Topper81 changed the title to Behaviour for PRF / ACM / ACM Exit not clear
Posted (edited)

I wasn't even aware of this bug since I always exit ACM (except guns) by pressing 'Undesignate' button and the fastest way to get back to your pre-configured setup for RWS for any weapon is by cycling weapons select switch to that weapon. 

If ACM was entered from TWS, this method will bring you back to TWS with Az/bars and PRF previously set.

 


Edited by Gripes323
Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...