Jump to content

MMJOY2 / MICRO PRO


Recommended Posts

Hello.

I have a smal button box with MICRO PRO and MMJOY2. It worked very well.

Yesterday i want to plug in a second Buttonbox wit also MICRO PRO and MMJOY2.

That has not worked in cause of same VID/PID so i installed ARDOINO-Software to change the VID/PID of one.

That has not worked so i deleted the ARDOINO Software.

 

After that i want to use my first Buttonbox to play DCS, but it das not work anymore. My first button box is recognized by MMJOY2 (Stick is blue)

but does not work with any other Program (DCS, TrackIR, ...)

If i press a button on the Box, i see the usually red lit of the button i pressed in MMJOY2.

So the Signal goes from the Box to MMJOY2 but not any further.

What is wrong?

 

Thank you for your help.


 
Link to comment
Share on other sites

For each board you can use individual VID/PID combination using numbers from 0000 to 9999 and for name any with up to 10 characters*, e.g. Panel1, Panel2...

 

* Back in time during MMjoy2 development are talk about increase this limit, don't know if was was done.

Link to comment
Share on other sites

This was not my question.

"I press a button and the signal goes from the button to MMJOY2 but not to DCS Ingame." ???

 

BTW:

If i change VID/PID from 8888 to anotherone may be 8887, and save it to the divice there is an error: "Device not integrated"

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...