Copy Thrustmaster settings from A-10C to A-10 II

[AvgWhiteGuy]

Just started getting back into DCS after long hiatus. Purchased A-10C II months ago but never set it up until this weekend and found my HOTUS settings, especially AXIS were all messed up. I was wondering whether I can copy some LUA from A-10C to A-10C II. 

 

Appreciate some advise,

[Leg2ion]

Try either a rescan or unplugging the controllers from the USB then plugging them back in with DCS running.

[LeCuvier]

If you are using the TM Warthog throttle and stick you should use the "reset to default" function.

[AvgWhiteGuy]

Thanks, got 90% sorted by copying the LUA files from A-10C, only need to get the Snapviews fixed again. This plane with the addition of helmet display has taken killer to a new extreme level  Sad they couldn't add more intelligent navigation like the F/A-18 but this is FUN!!!

 

Thanks again,

[Hammer1-1]

Not sure how much that would have helped as there are some key commands that are redundant in the CII.

[AvgWhiteGuy]

Hammer1-1, are you suggesting that it would be better to "reset to default" as mentioned above? I certainly would like to avoid the headaches of redundancy if possible. I'm ready to listen to any suggestions right now to get back in the air.

 

THanks

[Hammer1-1]

some are backwards from the original, so they wont work. Hard to tell which ones, but theres quite a few of them that are redundant. Its best to make new ones.