Jump to content

FA18C Case I, can trim up for E-bracket to come down, but cannot correct E-bracket back up when needed.


Recommended Posts

Returned after quite a while to FA18C and doing Case I training (MSFS & F14, installed fresh 2.7) and noticed

when I in final break, gear down, full flaps, that trimming up with TMWH HAT binding, the E-bracket can be brought down as it is supposed to towards the 8 dgs on the bar,

but that when one tries to correct back up again when needed,

 

the E-bracket is stuck in the position it was trimmed down to.

 

This was not the case as I can remember many months ago.

// Complete fresh install DCS 2.7.0.5118

 

 

| VR goggles | Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | MS FFB 2 | Throttle Quadrants | 8600K | GTX 1080 | 64GB RAM| Win 10 x64 | Voicerecognition | 50" UHD TV monitor | 40" 1080p TV monitor | 2x 24" 1080p side monitors | 24" 1080p touchscreen |

Link to post
Share on other sites

Please include a short track replay example. 

 

Not seeing a problem here. 

 

thanks

smallCATPILOT.PNG.04bbece1b27ff1b2c193b174ec410fc0.PNG

Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status

Windows 10 Pro x64, NVIDIA MSI RTX 2080Ti VENTUS GP, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 32GB DDR @3000, ASUS ROG Strix Z490-F Gaming, HP Reverb G2

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...