Jump to content

Recommended Posts

Hopefully ED will add those once they are done with the Hornet. For the interim, I added these 2 lines to "default.lua". I use the two bindings with the FLAPS 3-position switch on the TM WH throttle.

{down = control_commands.ApPitchAlt_EXT, up = control_commands.ApPitchAlt_EXT, cockpit_device_id = devices.CONTROL_INTERFACE, value_down =  1.0, value_up = -1.0, name = _('Autopilot PITCH Switch ALT HOLD/OFF'), category = {_('Instrument Panel'), _('FLCS')}},
{down = control_commands.ApPitchAtt_EXT, up = control_commands.ApPitchAlt_EXT, cockpit_device_id = devices.CONTROL_INTERFACE, value_down = -1.0, value_up = -1.0, name = _('Autopilot PITCH Switch ATT HOLD/OFF'), category = {_('Instrument Panel'), _('FLCS')}},

 

  • Thanks 1

LeCuvier

Windows 10 Pro 64Bit | i7-4790 CPU |16 GB RAM|SSD System Disk|SSD Gaming Disk| MSI GTX-1080 Gaming 8 GB| Acer XB270HU | TM Warthog HOTAS | VKB Gladiator Pro | MongoosT-50 | MFG Crosswind Pedals | TrackIR 5

Link to post
Share on other sites
4 minutes ago, LeCuvier said:

Hopefully ED will add those once they are done with the Hornet. For the interim, I added these 2 lines to "default.lua". I use the two bindings with the FLAPS 3-position switch on the TM WH throttle.


{down = control_commands.ApPitchAlt_EXT, up = control_commands.ApPitchAlt_EXT, cockpit_device_id = devices.CONTROL_INTERFACE, value_down =  1.0, value_up = -1.0, name = _('Autopilot PITCH Switch ALT HOLD/OFF'), category = {_('Instrument Panel'), _('FLCS')}},
{down = control_commands.ApPitchAtt_EXT, up = control_commands.ApPitchAlt_EXT, cockpit_device_id = devices.CONTROL_INTERFACE, value_down = -1.0, value_up = -1.0, name = _('Autopilot PITCH Switch ATT HOLD/OFF'), category = {_('Instrument Panel'), _('FLCS')}},

 

Alternatively you could use Joystick Gremlin to make WH 3-position switches send a different buttonpress on each position instead of the middle(?) position as OFF. My WH became only really useful after I figured out how to do that.

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...