Jump to content

Fighterstick Parts Source


Recommended Posts

The HAT's on top of grip are soldered in an PCB and this is not available as spare parts.

 

The side thumb HAT are modular and available in Mouser, Digikey, under APEM brand, for ~$35.

 

An HAT can be "overhauling" replacing the four tactile micro switches inside, of course require DIY skill and tools.

 

 

Link to post
Share on other sites

OUTSTANDING news !!  Thank you for the reply and the valuable information.

I have some tactile micro switches;  perhaps some that will fit.  I'll  follow up

here after the "rebuild".

Best regards,

Ken

Link to post
Share on other sites

In the CH hatswitches high quality OMRON tactiles are used. The exact type is OMRON B3F-1022.

 

If you are skilled at soldering, you can easily desolder the POV tactiles from the PCB and replace them with new ones. I have done the same on several CH sticks. Good luck! 🙂


Edited by rel4y

Cougar, CH and Saitek PnP hall sensor kits + shift registers: https://forums.eagle.ru/showthread.php?t=220916

 

Shapeways store for DIY flight simming equipment and repair: https://www.shapeways.com/shops/rel4y-diy-joystick-flight-simming

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...