ZeroReady Posted April 3, 2021 Share Posted April 3, 2021 When you're in the air, can you only edit existing waypoints? I was in the backseat with a friend, we were flying through the inferno. Started in a hot jet. So there were no waypoints loaded at takeoff. I wanted to set an IP. After inputting the Lat Long for IP it never showed up in the TID and the HSI. Link to comment Share on other sites More sharing options...
Saber2243 Posted April 3, 2021 Share Posted April 3, 2021 You can, the procedure is the same as on the ground 1. select the waypoint on the CAP panel 2. punch in lat-long as you would for ground alignment or any waypoint things to make sure of: you put the lat long in the correct format degrees, minutes, decimal minute you have the right N/S E/W set when entering the waypoint your INS is aligned correctly and has not drifted The waypoint is in the TID field of view Link to comment Share on other sites More sharing options...
ZeroReady Posted April 3, 2021 Author Share Posted April 3, 2021 Well I don't know what went wrong then, it seemed all of those requirements were met. I'll have to try it again. Thank you! 1 Link to comment Share on other sites More sharing options...
Recommended Posts