Select Jettison Behavior

[2alpha-down0]

With all pylons loaded and selected, the Select Jettison function will currently release Station 4, then stop.  No matter how long the button is depressed, it will not release 3 and 5 until the centerline (4) is deselected.  Once 4 is deselected, 3 and 5 will jettison with a subsequent button press, however 2 and 6 will still remain.  Deselecting 3 and 5 will allow 2 and 6 to be jettisoned.

 

This holds true if trying to jettison 2, 3, 5, and 6 as well (i.e.: keeping the centerline but dumping all wing stores); only 2/5 jettison, then those pylons need to be deselected before 2/6 can go.

 

Is this expected behavior?  The TO-1 doesn't mention this behavior (pages 1-67 to 1-68).  It mentions dumping in pairs, but is it supposed to stop the sequence after each pair?

 

Here's a video showing the sequence:

https://www.youtube.com/watch?v=vIOuhcc9QEY

select jettison failure 2.trk

Edited April 1, 2021 by 2alpha-down0

[Golo]

For select jettison only one release or pair release will occur for reach actuation of select jettison button. The released station(s) must be deselected before another store can be jettisoned.

That is a correct operation and -1 does mention it in JETTISON SYSTEM, so does the DCS F-5 Manual. 

[2alpha-down0]

6 hours ago, Golo said:

For select jettison only one release or pair release will occur for reach actuation of select jettison button. The released station(s) must be deselected before another store can be jettisoned.

That is a correct operation and -1 does mention it in JETTISON SYSTEM, so does the DCS F-5 Manual. 

 

Ah, I looked in the wrong part of the -1; I see it now.  Thanks.