Jump to content

A-A radar RWS to TWS shall not stow TDC


Recommended Posts

The present RWS to TWS into MAN mode via RDDI5 shall leave the TDC as is, not stow it, as this is the correct APG-73 implementation.

 

With the present incorrect implementation, the RWS to TWS change corrupts the radar's track file, see appended track file.

2021.03.29 F-18 vs 7 Mig29 targets 2kft to 40kft.trk

  • Like 1

____________________________

HP Envy 34 TM16000/TWCS/TFRP. Simrig: I7-8700, 32GB, RTS2080Ti, 4K U32590C, TrackIR5, MG-T50C2 stick/base, T50CM2 throttle, CH Pro pedals

Link to post
Share on other sites

Hi,

 

do you have any reference for this? if so please PM me

 

thank you

smallCATPILOT.PNG.04bbece1b27ff1b2c193b174ec410fc0.PNG

Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status

Windows 10 Pro x64, NVIDIA MSI RTX 2080Ti VENTUS GP, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 32GB DDR @3000, ASUS ROG Strix Z490-F Gaming, HP Reverb G2

Link to post
Share on other sites
Posted (edited)

I reported to BIGNEWY that an F-18C pilot told me the stowing of the DCT at RWS>TWS is incorrect, it shall not move. 


Edited by Bear21

____________________________

HP Envy 34 TM16000/TWCS/TFRP. Simrig: I7-8700, 32GB, RTS2080Ti, 4K U32590C, TrackIR5, MG-T50C2 stick/base, T50CM2 throttle, CH Pro pedals

Link to post
Share on other sites

I'm guessing that it does stow, it just doesn't change the scan volume until you move the tdc back out of the gutter. This would make sense especially if you used the cursor to switch from RWS to TWS. In no other scenario does the scan volume react to a TDC outside the radar box except this one, pointing to it likely being incorrect behavior. Sim code seems to treat the cursor as active between where it was and the stowed position. Likely fix is cursor should disappear and reappear stowed, or be treated as inactive until reaching the stowed position.

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...