Jump to content

Does anybody have experience of a RTX 3060ti and DCS VR


Recommended Posts

Hi everyone, I have a trusty 1080ti 11gb which I’ve had for a time now. I have been getting good results in DCS VR on a HP reverb G1, but with the Syria map unless I set visible range to high I get this strange anomaly at the edge of the object draw distance, trees mainly, some only appear in one eye just at the edge of the draw distance, this goes if I set Vis range to high. However at high when I fly over areas with lots of buildings it’s too taxing and my FPS drop to 40 sometimes into the 30s and I can see my GPU is maxed out. My plan was to wait and see what happens when Vulcan is implemented later this year. But I’ve seen an opportunity to get a RTX 3060ti 8gb for £500. Does anybody have experience with this card with DCS and could give some advice, would I notice an improvement over the 1080ti for VR, or would it be a backwards step having only 8gb. 
Advice would be appreciated. 

harrier landing GIFRYZEN 7 3700X Running at 4.35 GHz

NVIDIA GeForce GTX 1080Ti

32gb DDR4 RAM @3200 MHz

Oculus CV1 NvME 970 EVO

TM Warthog Stick & Throttle plus 11" extension. VKB T-Rudder MKIV

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...