Jump to content

ATFLIR coordinate display alignment bug


Recommended Posts

The position of the coordinate display is slightly different than real life.

 

There are two differences:

 

1. The entire coordinate display is too close to the sensor priority diamond (can be seen in the video below). It should be moved slightly to the left.
2. N, E, ELEV, should all be aligned (start at the same position). Grid is fine the way it is.

It should look like this:

 

N XX XX XXX

E XX XX XXX

ELEV XXX (elev does not display the unit of measure)
 

At the moment, it looks like that in DCS:

 

    N XX XX XXX

    E XX XX XXX

ELEV            XXX

 

I apologize for the bad quality. I will try to find a better video \ pic.

 

 


Here's another photo of the coordinate format. Notice the elevation line doesn't have the unit of measure (it's feet all the time).

https://i.imgur.com/6X6f5Wl.jpg


Edited by BarTzi
  • Like 3
Link to post
Share on other sites
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...