solved Datalink doesn't work

[Alaxa]

 hi I've followed tutorials on Youtube however Datalink doesn't work

I don't know where i set it wrong

Please explain to me how I should properly set it

 

thanks in advance

Edited February 14 by Alaxa

[Jef Costello]

DL switch is OFF on the right console!

[Badlego]

DL switch is not referring to Link-16 but to some other system which is not implemented in the viper block we have here, AFAIK. Therefore it is a dead switch without any functions. The Map switch is also not necessary.

Without a track it is not possible to see what the issue is. The screenshots do not help as they do not show, i. e. the align status of your plane or if it is an airborne start or cold start on the ground.

Edited February 14 by Badlego

[Alaxa]

19 minutes ago, Jef Costello said:

DL switch is OFF on the right console!

Thank you for the solution but Isn't it already turned off?

 

Edited February 14 by Alaxa

[Alaxa]

14 minutes ago, Badlego said:

DL switch is not referring to Link-16 but to some other system which is not implemented in the viper block we have here, AFAIK. Therefore it is a dead switch without any functions. The Map switch is also not necessary.

Without a track it is not possible to see what the issue is. The screenshots do not help as they do not show, i. e. the align status of your plane or if it is an airborne start or cold start on the ground.

 

Thank you

Well.. It seems I need to learn all things from cold and dark again :///

Edited February 14 by Alaxa

[frasberry]

I have been reading around forums(and tried it).Link-16 relies alot on proper alignment so when your on the ground and you start your alignment hit enter on your lat and lon coordinates with in a min. or two of you starting your alignment. fixed the link-16 problem you are having. I was having the same issue and that fixed mine. Hope this helps! safe flying!

Edited February 15 by frasberry

[Jef Costello]

19 hours ago, Badlego said:

DL switch is not referring to Link-16 but to some other system which is not implemented in the viper block we have here, AFAIK. Therefore it is a dead switch without any functions. The Map switch is also not necessary.

Without a track it is not possible to see what the issue is. The screenshots do not help as they do not show, i. e. the align status of your plane or if it is an airborne start or cold start on the ground.

 

Thanks a lot for the insight

[WHOGX5]

A good thing to keep in mind is that A-A TACAN can interfere with D/L. I don't know if you know about yardstick, but basically if you have two aircraft tune TACAN channels that are 63 channels apart you can get distance between between the two aircraft. I don't have the scientific explanation for it, but IIRC it's something about the channels doubling in frequency or something. So as you can see in the illustration below for A-A TACAN, channels 1-36 and their respective "sister" channels 63 above are unavailable. If these are tuned it will most likely interfere with D/L. So make sure that the mission you're flying have all A-A TACAN set to 37-63 and 100-126. It doesn't necessarily be the cause of the issue you're having, but it's a good thing to keep in mind.