cannot reproduce TRIM elevator control stuck

[OBT-Mikmak]

I got a strange and annoying behaviour of my TRIM elevator control switch in FW 190 A8 and D9.

When i release my TRIM button (HOTAS or Keyboard), this switch stay stuck in down or up position during few seconds (images 2 and 3) instead of returning back immediately to neutral position (image 1).

This happen only when i play on flat screen.

There is no problem when i use VR Headset.

I checked that no multiple control mapping interferences occur.

I have done a DCS repair .

How can i get back a normal behaviour for my TRIM elevator control switch on flat screen ?

 

 

 

 

 

Edited January 24, 2021 by OBT-Mikmak

[YoYo]

I think its your control configuration. Check keys, buttons (pressed) ect. I have binded trimm on my joystick and no any problems with this. It works as it should. The best way is to use monitoring program what you pressed (you can find in the Net, free tools).

Edited January 24, 2021 by YoYo

[LeCuvier]

I use a flat screen with TrackIR, and the trim function using the POV hat on my stick works correctly. I can frankly not imagine why HOTAS commands would work differently with VR. But you might still want to check UI Layer bindings. (instead of selecting an aircraft, seclect UI Layer). UI Layer bindings override everything else.

I assume you have not set up any modification that yould interfere? If you are using Thrustmaster's TARGET software, make sure you have not built in any button hold.

If you don't find a solution I recommend you open a ticket with support. They are good.