Jump to content

Hornet BALT AP Mode


foxonefoxtwo
 Share

Recommended Posts

Check your pitch axis dead zones. You can often allow engagement by just touching the stick in the pitch axis to centre it again. Try increasing the dead zone by 1. My Warthog needs a deadzone of 3. Other sticks may need more

hmm for a few months this summer i was having to push the stick forward a hair and it would engage. As of last update It's no longer needed, I changed nothing.

Nobody likes me because I'm unsafe.

Link to comment
Share on other sites

Yeah more than likely a deadzone problem. Joystick falling out of calibration slightly over time is likely the issue.

i9 9900K @ 5.1Ghz - ASUS Maximus Hero XI - 32GB 4266 DDR4 RAM - ASUS RTX 2080Ti - 1 TB NVME - NZXT Kraken 62 Watercooling System - Thrustmaster Warthog Hotas (Virpil Base) - MFG Crosswind Pedals - Pimax 5K+

VFA-25 Fist Of The Fleet

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...