Jump to content

[ALREADY REPORTED]MAV+TPOD doesn't work against moving target


Recommended Posts

MAV is constantly slewed to the initial position desginated by TGP, even if uncaged. There's no handoff. If it happens to lock the target and the target moves, it will fight for a while, switching between ground designation and target tracking several times per second, and eventually it will loose the target.

 

The only way to stop this is to undesignate and loose TPOD track.

 

In the attached track you will see that after locking the first vehicle in the convoy, MAV will constantly jitter and switch targets, until the whole convoy passes through the initial designation point.

MAVPTRK.trk

Hardware: Virpil T-50CM, Hotas Warthog, Hotas Cougar, Slaw Rudder, Wheel Stand Pro, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Reverb

Link to post
Share on other sites

Hi

 

This is already reported, the jittery lock will be looked at by the team, however I want to mention you are trying to get a lock to far out, at maximum range it will be more difficult.

 

thanks

smallCATPILOT.PNG.04bbece1b27ff1b2c193b174ec410fc0.PNG

Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status

Windows 10 Pro x64, NVIDIA MSI RTX 2080Ti VENTUS GP, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 32GB DDR @3000, ASUS ROG Strix Z490-F Gaming, HP Reverb G2

Link to post
Share on other sites

Locking distance is not the subject of this report.

 

The problem is Mav can't follow a moving target once locked, because it's constantly forced to look at the point designated by TGP. No matter if it locked at 5 or 10 nm. This creates the "jittery" lock effect.

Same happens when the target is not moving, but the TGP designation is not right on top of the target.


Edited by some1

Hardware: Virpil T-50CM, Hotas Warthog, Hotas Cougar, Slaw Rudder, Wheel Stand Pro, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Reverb

Link to post
Share on other sites
Locking distance is not the subject of this report.

 

The problem is Mav can't follow a moving target once locked, because it's constantly forced to look at the point designated by TGP. No matter if it locked at 5 or 10 nm. This creates the "jittery" lock effect.

Same happens when the target is not moving, but the TGP designation is not right on top of the target.

 

Just in case they are looking at the wrong issue...

 

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...