Legs Posted April 18, 2020 Share Posted April 18, 2020 Is this a thing yet? I was told a workaround was to edit an existing point and it would work but I have had no luck. TIA Sent from my SM-G973U using Tapatalk LEGS - JTF-13 Link to comment Share on other sites More sharing options...
Emmy Posted April 18, 2020 Share Posted April 18, 2020 Don’t think it’s a thing yet. You can still only edit existing steerpoints. [sIGPIC][/sIGPIC] http://www.476vfightergroup.com/content.php High Quality Aviation Photography For Personal Enjoyment And Editorial Use. www.crosswindimages.com Link to comment Share on other sites More sharing options...
mkiii Posted April 18, 2020 Share Posted April 18, 2020 You mean you have no luck even with an existing SP? I just had a go with the Caucasus free flight mission and it let me edit SP 2 no problem. What sequence of buttons did you try? I did this after putting (AP to ATT Hold in a nice orbit):- ICP Inc/Dec button to get to WP I want to change. ICP STPT(4) button. Dobber down on the Data Control Switch to LAT Entry on DED. Press ICP (2) button to get N use ICP numbers to get xx -xx.xxx (Note degrees = 2 digits 0-90) Dobber down to LNG entry. Press ICP (6) to get E. use ICP numbers to get xxx - xx.xxx (note degrees = 3 digits 0-180) press Return on the Data Control Switch I intially made the mistake of not using 3 digits on the Easting (044deg, not 44deg). Link to comment Share on other sites More sharing options...
Legs Posted April 18, 2020 Author Share Posted April 18, 2020 You mean you have no luck even with an existing SP? I just had a go with the Caucasus free flight mission and it let me edit SP 2 no problem. What sequence of buttons did you try? I did this after putting (AP to ATT Hold in a nice orbit):- ICP Inc/Dec button to get to WP I want to change. ICP STPT(4) button. Dobber down on the Data Control Switch to LAT Entry on DED. Press ICP (2) button to get N use ICP numbers to get xx -xx.xxx (Note degrees = 2 digits 0-90) Dobber down to LNG entry. Press ICP (6) to get E. use ICP numbers to get xxx - xx.xxx (note degrees = 3 digits 0-180) press Return on the Data Control Switch I intially made the mistake of not using 3 digits on the Easting (044deg, not 44deg).I'll give it a try Sent from my SM-G973U using Tapatalk LEGS - JTF-13 Link to comment Share on other sites More sharing options...
mkiii Posted April 18, 2020 Share Posted April 18, 2020 All that said - the input does seem a bit tempremental - if it does something odd - just use RCL to start the entry again. Link to comment Share on other sites More sharing options...
Recommended Posts