Jump to content

mission 3 - Wpts and INS not matching


Julian Kraiz
 Share

Recommended Posts

Hello,

I saw anothe rpost about INS alignment but my issue is a bit different :

After a full alignment, when I double check my INS wpt pointed to in the HSI, it is off by 10nm N-N-W from the wpt shown in the f10 map.

 

 

This causes me to miss some interactions.

 

 

Additionaly, when I choose to go check some tallies at a given GPS coordinates, I can't seem to go to the right location.

I don't have the actual values right now, but even when converting to deg-min-dec system, I'm never in the right spot to continue the radio interaction stating I confirm the position of the possible hostile (It worked once but I go shot down a bit later, and can't do it again now).

 

 

Any idea of what could cause my problem?

 

 

Thanks !

Link to comment
Share on other sites

  • 1 month later...
Hi, Yes I've used the kneboard position for alignement.

Never being sure wether it's in deg,min,dec or deg,min,sec, i tried converting too, but it's doesn't change much.

 

 

Also it's a solid 10nm, not the slight 1nm/hour of INS drift.

 

 

I had similar problems but took the coords from the F10 map in deg sec,deci and it worked fine

Link to comment
Share on other sites

  • 7 months later...
 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...