[FIXED] CM-802AKG and C-802AK missiles do not function properly on Cold Starts.

[J20Stronk]

Much like other bugs, the CM-802AKG and C-802AK do not function properly in aircraft that are started cold and dark.

 

In a cold start the CM-802AKG fails to guide itself to the target regardless of mode used (DIR, COO, or MAN). Instead it begins to fly to the top left corner of the theater's playable area, for example an AKG missile fired from Kutaisi will turn to heading 292-293 and fly at the altitude it was fired from before de-spawning a few moments later. The MITL POD page shows this same heading and LAT LONG of the missile properly, but no TKJ, no RP#s if fired in MAN on the OSB L1 and L2, and shows 0nm to target.

 

In an airborne or pre-started plane on the ramp or runway, the missile behaves just fine and follows the selected guidance options you set for it.

 

On the other hand, the C-802AK simply does not fire on a cold start plane. Master arm is on, Alignment period completes, and target is set in all modes, but the missile will not come off the rail.

 

Again, the missile fires and guide itself just fine in an airborne or hot-started Thunder.

 

 

DCS log.txt below

 

 

PS: Also, it doesn't matter if the missile or DL pod were re-armed, just if the aicraft was started cold or not.

PSS: I did wait for the 802AKG to fully align as well.

dcs.txt

Edited December 6, 2019 by L0op8ack

[toilet2000]

Can confirm this is an issue. See attached track.

 

Same kind of issue as with the TPOD.

JF-17_cm_802akg_bug.trk

[L0op8ack]

Can confirm this is an issue. See attached track.

 

Same kind of issue as with the TPOD.

 

 

Will dig into this bug.

[paco2002]

I was trying to fire them, but yep, I just read that, any news on that Loop8ack?

[Eihort]

Is TOO mode still a thing for the AKG, like was said and shown in the original video? I can't even get it to come up on an air started plane.

[L0op8ack]

I was trying to fire them, but yep, I just read that, any news on that Loop8ack?

 

 

Fix internally, tester team will check.

Available next update.

 

 

Thanks for reporting.

[Zarma]

C-802AK working fine in cold start for me...