Jump to content

[BUG] Switch Seats Binding


Recommended Posts

The binding for switching between pilot and RIO seats is 1 and 2 by default. I rebound it to - and = because i wanted to use 1-8 for the jester wheel.

 

Now, I can switch to the RIO seat with = but I can't switch back to the pilot seat with -

 

I have to still use 1 to switch back to the pilot seat, even though it's been rebound to "Command 1" for the jester wheel.

 

I tried unbinding and rebinding but no luck


Edited by IronMike
Link to post
Share on other sites
  • 2 months later...

I run into the same issue yesterday when i want to use the canopy toogle as rio. I think there are two bindings for rio and for pilot. You changed the selection in the pilot controll settings but not in Rio Settings.

 

When you switch to Rio, you switch control settings and its the original settings.

 

Please check that. :)

Link to post
Share on other sites
I run into the same issue yesterday when i want to use the canopy toogle as rio. I think there are two bindings for rio and for pilot. You changed the selection in the pilot controll settings but not in Rio Settings.

 

When you switch to Rio, you switch control settings and its the original settings.

 

Please check that. :)

 

Fixed :thumbup:

 

"occupy pilot seat" must be bound from the rio controls and vice versa

Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...