Jump to content

Throttle dead zone


Eldur
 Share

Recommended Posts

Is it just me or are the first ~10% of the throttle axis range dead? I have to move my HOTAS Warthog throttle for a considerably large amount until the throttle in the cockpit even starts moving into the first detent (flight idle)... on the upper end it's fine twilightsmile.png

 

FYI: No changes to axis settings made...

dcsdashie-hb-ed.jpg

 

Link to comment
Share on other sites

Is it just me or are the first ~10% of the throttle axis range dead? I have to move my HOTAS Warthog throttle for a considerably large amount until the throttle in the cockpit even starts moving into the first detent (flight idle)... on the upper end it's fine twilightsmile.png

 

FYI: No changes to axis settings made...

 

There is a gap between ground idle and flight idle.

Link to comment
Share on other sites

That's not what I meant. There is a dead zone even before the ground idle. I set the axis deadzone to 8%, then it's just as I would expect it. Just move the throttle a tad forward and it goes into flight idle. Without the deadzone setting the throttle actually doesn't move at all for the first just a bit over 8%.

dcsdashie-hb-ed.jpg

 

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...