Jump to content

rudder pedals not recognised


Snail
 Share

Recommended Posts

I'm setting up a new computer and most of it goes well. One exeption: in DCS world 1.5 my CH rudder pedals aren't recognised (the axis I mean: the device is listed). They do work in the CH control manager and in another flight sim, but DCS is blind to them so far.

 

See setup / axis screen below. As I have understood, it is a matter of clearing the right cell, selecting it, clicking Axis Assign and moving the rudder axis. If I do, nothing happens. I have also looked at the Add screen. In only shows the 3 HOTAS axis to assign: roll, pitch and throttle.

 

In the all commands screen I have cleared all related flight control key assignments.

 

Any ideas?

Image2.thumb.jpg.3af7fba5b6185e2acc40fb7ef3613089.jpg

How (s)low can you go

Link to comment
Share on other sites

select correct cell (as you have in your screenshot), then click 'add'.

Now move the rudder pedals back and forth a few times until they are registered.

For some reason, my CH pedals are slow to register, yours may be the same.

Intel Core i7 6700K @ 4.5GHz. Asus-Z170-PRO MB

CORSAIR H105 HYDRO CPU COOLER.

EVGA GTX 1080Ti FTW3 Elite.

16GB DDR4 2666MHZ HYPERX SAVAGE.

SAMSUNG M.2 SSD 128GB SM951 Boot Drive.

SAMSUNG SSD 500GB EVO Working Drive.

Windows 10 Professional

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...