Jump to content

Recommended Posts

Hehe looks like you got all black and silver hardware just like me (totaly by accident in my case, even my TFT monitor has blue LED's as my X52)

[sigpic]http://forums.eagle.ru/signaturepics/sigpic4448_29.gif[/sigpic]

My PC specs below:

Case: Corsair 400C

PSU: SEASONIC SS-760XP2 760W Platinum

CPU: AMD RYZEN 3900X (12C/24T)

RAM: 32 GB 4266Mhz (two 2x8 kits) of trident Z RGB @3600Mhz CL 14 CR=1T

MOBO: ASUS CROSSHAIR HERO VI AM4

GFX: GTX 1080Ti MSI Gaming X

Cooler: NXZT Kraken X62 280mm AIO

Storage: Samsung 960 EVO 1TB M.2+6GB WD 6Gb red

HOTAS: Thrustmaster Warthog + CH pro pedals

Monitor: Gigabyte AORUS AD27QD Freesync HDR400 1440P

 

Link to post
Share on other sites

AJ- If you had to you could use a hacksaw. since the lenghts of PVC slip into the joints a super precise cut is unnecessary...so long as you keep the exposed sections of PVC the same length.

 

Gazehound- sorry you can't know the joy of loading up ammo for your own use! But instead of lead bullets..you could fill the lower sections of PVC with sand. that would provide adequate weight albeit without the convenience of being able to keep them lightweight for storage/transport.

[sIGPIC][/sIGPIC]

 



 

Link to post
Share on other sites

table saw would work perfectly for cutting the wood... since the pvc is only 1" u can but these cutting pliers (w/e it is) that u measure out the length make a like... and cut it.... worked awesome for me!

 

its really simple to make the directions are all in colts link. i did his measurements and they didnt work for me. So i had to cut off the bottoms at a length that worked for me then i rebuilt the bottom. I actually have my throttle sitting about 4 inches (i think) lower then my stick because its more comfortable.... to me it was all about getting the sticks off the desk and having comfort. I achieved both, and it looks really nice!

guppysig.jpg
Link to post
Share on other sites
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...