Yet another warthog slew upgrade - Page 52 - ED Forums
 


Notices

Reply
 
Thread Tools Display Modes
Old 11-16-2018, 09:44 AM   #511
MTFDarkEagle
Veteran
 
MTFDarkEagle's Avatar
 
Join Date: Nov 2008
Location: The Netherlands, near EHTW
Posts: 4,881
Default

Holy hell... How did I not come across this earlier??

Well done! I'll definitely pick this up at some point soon.
Looking forward to trying it.
__________________
MTFDarkEagle is offline   Reply With Quote
Old 11-16-2018, 01:37 PM   #512
Sydy
Member
 
Sydy's Avatar
 
Join Date: Jan 2014
Location: Brazil
Posts: 560
Default

Quote:
Originally Posted by MTFDarkEagle View Post
Holy hell... How did I not come across this earlier??

Well done! I'll definitely pick this up at some point soon.
Looking forward to trying it.
You’re gonna love it. I can vouch for that.

Good luck,

Sydy
Sydy is offline   Reply With Quote
Old 11-16-2018, 04:18 PM   #513
Phoenix FR
Junior Member
 
Join Date: Jan 2009
Location: Bordeaux
Posts: 93
Default

I had the same problem and here is how i solved it.


My warthog when i opened it.




You have to open the back plate.

Remove the black scotch. Then, you have to push on the cable from one side while you pull the cable from the orther side. But the risk is that you cut the cable.



And what i had after :




Keep in mind that you can cut or damage the cable.
Phoenix FR is offline   Reply With Quote
Old 11-16-2018, 06:10 PM   #514
hreich
Member
 
hreich's Avatar
 
Join Date: May 2005
Posts: 946
Default

Quote:
Originally Posted by Phoenix FR View Post
I had the same problem and here is how i solved it.


My warthog when i opened it.




You have to open the back plate.

Remove the black scotch. Then, you have to push on the cable from one side while you pull the cable from the orther side. But the risk is that you cut the cable.



And what i had after :




Keep in mind that you can cut or damage the cable.
Thanks.. I solved it same way but beforw i saw your post

Sent from my Redmi Note 4 using Tapatalk
__________________

Pilot from Croatia
hreich is offline   Reply With Quote
Old 11-16-2018, 07:19 PM   #515
Deltaalphalima1
Member
 
Deltaalphalima1's Avatar
 
Join Date: Apr 2017
Location: UK
Posts: 100
Default

Quote:
Originally Posted by hreich View Post
After around 2 hours i managed to connect slew replacement, but i also found why i couldn move side with 3 switches down to 90 degrees.. Because this connector that goes to bottom of stick and which i accidentaly disconnected.
Now i have another problem i cannot connect it bak because wire is too short..I have to found how to open bottom of throttle so i can free some length of that wire so i can connect it back..

Deltaalphalima1 - maybe you could update your instructions to mention three things:
1. about wires that are short and prevent to freely open side of throttle with 3 switches (mine disconnected only when my throttle tipped over on my desk by accident) - i didnt even know that it prevents me from opening the side with 3 switches (thumbnail picture shows how far i could open that side - it was too small to reach the slew pot)
2. about how to remove the slew cap
3. about that you have to remove the plate from slew mounts - so you can mount the slew in throttle, and then place the plate back

If somebody knows can i remove the other side of cover where there are no switches and how? Maybe i can connect cable through backside?

Sent from my Redmi Note 4 using Tapatalk

Sorry to hear you have had some troubles - I will look into adding your suggestions to the install guide.

From your pictures it looks like there must be some differences in the manufacturing tolerances on some throttles with the bottom cable. In my unit for example there is plenty of slack to completely remove the side plate with it still connected, but clearly yours is not as long.

Would you mind sharing you throttle serial number or approximately when you bought it so I can see if there is a pattern?
__________________
Specs: i7 7700K delid @ 4.8GHZ, MSI Gaming X GTX1080, ASUS Strix Z270G, 32GB Corsair LPX @ 3000MHz, Noctua NH-U12S, EVGA 750 P2, Fractal Define Mini C
Hardware: Thrustmaster Warthog, TrackIR 5, MFG Crosswinds(4757) , Custom Helicopter Collective

www.deltasimelectronics.com
Deltaalphalima1 is offline   Reply With Quote
Old 11-16-2018, 07:49 PM   #516
Phoenix FR
Junior Member
 
Join Date: Jan 2009
Location: Bordeaux
Posts: 93
Default

Mine is from the launch of the warthog and my number is 01085.
Phoenix FR is offline   Reply With Quote
Old 11-16-2018, 09:11 PM   #517
hreich
Member
 
hreich's Avatar
 
Join Date: May 2005
Posts: 946
Default

Mine is also at the launch and serial 01465

Sent from my Redmi Note 4 using Tapatalk
__________________

Pilot from Croatia
hreich is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 02:34 AM. vBulletin Skin by ForumMonkeys. Powered by vBulletin®.
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.