Jump to content

DTOT working correctly?


GazAce

Recommended Posts

Hi groovy Pilots,

I'm just wondering if anyone is having dramas with setting DTOT either using their CDU or UFC? I'm probably doing this incorrectly but when I set the desired time at any specific WP and then when I cycle thru them, all are showing same time. I can't seem to find any docs on this other than the manual pages 470 -471 and yes it explained the method but I'm still getting all the WPs set with same time? I'm a little freaked by this one as not being able to set each WP with a different DTOT.

Any buffs out there care to chime in and let me know what I'm doing wrong?

Would be much appreciated.

Regards G

book.gifhuh.gif

Oops I think I found where I was going wrong, was on the wrong page in CDU doh.gif

 

Nope, still not getting it.

Just watched the Bunyap Sims vid on this and it looked great but I still can't seem to have separate TOTs set for different WPs

sad.gif


Edited by GazAce

:: 13th Gen Intel Core i9-13900K :: Asus ROG Strix Z790-A mobo :: Asus Tuff Gaming GeForce RTX 3080 Ti :: NZXT Kraken Elite 280 RGB AIO white cooler :: G Skill Trident Z Royals DDR4 4x16GB = 64GB :: WD Black SN 850X NVMe SSD 2TB M.2 (C Drive) :: Samsung 860 Pro 2TB SATA (D Drive) :: Corsair Crystal 680X White Case :: Asus XG349C 34" Curve G-Sync 180Hz 3440x1440 Mon :: Corsair 850W PSU :: Virpil Constellation Alpha-R Stick with VPC WarBRD Base :: Virpil MongoosT-50CM3 Throttle :: 3 x CubeSim ext mini screens with TM Cougar MFD Bezels :: Asus ROG Pugio 503 Gaming Mouse & Razer BlackWidow mech kb :: TrackIR 5 Pro & Cap Clip :: Win 11 64 Bit 😉

Link to comment
Share on other sites

  • 1 year later...

You can set a TOT for every WP in the CDU.

The HUD will only show the required speed if a steerpoint with a set TOT is selected.

dUJOta.jpg

 

Windows 11 | i9 12900KF | 64GB DDR4 | RTX 3090 | TM Warthog HOTAS | Saitek Combat Rudder Pedals | TM MFDs + Lilliput 8" | TIR5 Pro

Link to comment
Share on other sites

You can set a TOT for every WP in the CDU.

The HUD will only show the required speed if a steerpoint with a set TOT is selected.

 

Thanks Stuka, I finally was able to figure it out! Had problem specially when setting for an offset location. But now it's clear.

 

Greets from Italy!

:pilotfly:

[sIGPIC][/sIGPIC]

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...