Migo Posted July 3, 2019 Share Posted July 3, 2019 I just upgraded my hardware and now DCS is showing me the activation dialogs for the A10c and FC3 modules. My serial numbers are already filled out when the dialog opens and when I confirm the activation DCS shows me that I have a few activations left. DCS then starts with the main menu but the activation dialogs are still sitting in the background. Once I restart DCS the dialogs pop up again. When I try to start an A10c mission I only see the map and cannot fly the plane. This is only happening with those 2 modules. The hornet is working fine for example. Link to comment Share on other sites More sharing options...
cthulhu68 Posted July 3, 2019 Share Posted July 3, 2019 (edited) If you didnt deactivate modules before pc change the registry gets confused on modules bound with a registry key. Near bottom of linked page is instructions for clearing registry, then reinstall. Technical questions https://www.digitalcombatsimulator.com/en/support/faq/564/ The section that says Activatiob problem due to pc change or integrity fault. Edited July 3, 2019 by cthulhu68 Link to comment Share on other sites More sharing options...
Migo Posted July 3, 2019 Author Share Posted July 3, 2019 Thanks for the quick reply. I'll give it a try. Link to comment Share on other sites More sharing options...
Migo Posted July 3, 2019 Author Share Posted July 3, 2019 Alright, running the reg-files for the two modules did the trick. Link to comment Share on other sites More sharing options...
Recommended Posts