iKyrThraad993i Posted July 2, 2018 Share Posted July 2, 2018 Currently I am using the HUD software from Logitech to do advanced key commands. My question is: If I use the Deadzone and axis calibration in the HUD software will the automatically override the stuff in DCS? I have the Axis assigned in DCS "Axis Assign" but have my deadzones and so on set up on the HUD software. Thanks for the help Link to comment Share on other sites More sharing options...
LOGIRich Posted July 3, 2018 Share Posted July 3, 2018 If you edit the axis curves in our software then those are the responses that are sent to your PC via HID because they're saved directly into the stick. DCS's deadzones should then layer on top of that info that comes through HID, so you may want to remove those from DCS. Link to comment Share on other sites More sharing options...
crab Posted July 3, 2018 Share Posted July 3, 2018 I set mine up by deleting them in DCS as they were wrong anyways and then adding them in (X, Y, rudder, throttles) correctly. From there I did everything in my profile including the dead zones and curves. Works fine. Link to comment Share on other sites More sharing options...
Recommended Posts