P51 A-G training nackered?

I'm trying to learn the P51 after jumping into the Instant Action Ground attack mission and finding I can't launch rockets at all (funny that secondary JS button works fine in an F86) and needed the KB to bomb (my CH Fighterstick isn't set up correctly). The training on the tarmac goes well until setting up the trim and then it stops. No freeze, just sits there and doesn't move on to the next step. Is it something i'm not doing correctly?

I couldn't reproduce any of that. The rockets come off fine for me. I could also complete the cold start training normally. Did you set up the trim as was requested?

I'm trying to learn the P51 after jumping into the Instant Action Ground attack mission and finding I can't launch rockets at all (funny that secondary JS button works fine in an F86) and needed the KB to bomb (my CH Fighterstick isn't set up correctly). The training on the tarmac goes well until setting up the trim and then it stops. No freeze, just sits there and doesn't move on to the next step. Is it something i'm not doing correctly?

i would assume that will be required to set rockets launch at weapon panel. If this is your keybinding problem you should sort it out with little effort anyway

if you got stuck in the mission just flip every switch back and fore, scripted trainin missions are so enoying for me some time you flip switch too early and whole training mission will stuck i just avoid them from very far best way to learn is hit manual or guide then practise it on some training server (there are plenty of them)