Jump to content

[REPORTED]HMD boresight not functioning after lock loss


Shadow KT

Recommended Posts

If you enable you are HMD and lock a target in boresight (Sensor Control Switch FWD) and then loose the radar behaves as if you don't have an HMD.

 

You can see the boresight circle in the HMD is no longer limited to the radar gimbals and if you put the circle on the target again (when it is offset from your nose) it will not lock it. You have to press Sensor Control Switch FWD again to fix it.

 

 

You can also notice that if you loose a lock you will only be able to lock a target again (without pressing anything additionally) if you put him on your nose (normal boresight, with no HMD)

Hornet Boresight HMD.trk

'Shadow'

 

Everybody gotta be offended and take it personally now-a-days

Link to comment
Share on other sites

  • 3 weeks later...

HMCS radar lock circle doesn't lock

 

How it used to be:

 

- Select ACM mode (e.g. guns)

- Castle switch up - radar lock circle appears on helmet visor

- Put target in the circle and the radar locks automatically, every time.

 

 

Now:

 

- Select ACM mode (e.g. guns)

- Castle switch up - radar lock circle appears on helmet visor

- Put target in the circle and the radar locks automatically the first time. When lock is lost / cancelled with pinky, it requires castle up again to re-lock even though the mode didn't change

Windows 10 - Intel i7 7700K 4.2 Ghz (no OC) - Asus Strix GTX 1080 8Gb - 16GB DDR4 (3000 MHz) - SSD 500GB + WD Black FZEX 1TB 6Gb/s

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...