Silent Warrior Posted April 21, 2006 Share Posted April 21, 2006 I have an X45, using someone's LOMAC 1.1-profile enabled through that systray-thingy. In there, the TD-box slewing-commands (, . - ö, swedish layout) are mapped to that little orange mouse-knob on the throttle-wossname. Left/right works fine, but the last time I tried (barely an hour ago, in fact), both up and down made the TD-box move downwards! :huh: To add insult to injury, I found the cause of the twitching I mentioned earlier in Tech Discussion (or so I hope), and it seems to require deadzone-adjusting (or some manner of greasy stuff). Now, the DZ-adjust-controlpanel was available once, when I mucked about with the drivers (no, you DON'T want to know), and now it's gone! AAAAK! There doesn't seem to be a registry-entry either! Link to comment Share on other sites More sharing options...
Prophet_169th Posted April 21, 2006 Share Posted April 21, 2006 If the Y axis is opposite of how you want it, just swap the assigned keys for the microstick up/down. Link to comment Share on other sites More sharing options...
Recommended Posts