ariyaner Posted October 7, 2019 Share Posted October 7, 2019 hi 4 the russian(sowjet) planes you have that funktion which changes the numbers (10 stock) in the bottom bvr hud what exatly it does ? is it working ? how to use ? thx Link to comment Share on other sites More sharing options...
draconus Posted October 7, 2019 Share Posted October 7, 2019 From DCS Mig manual: The expected (manual) range to target (often derived from AWACS and GCI data), as set by [RCtrl-+] and [RCtrl--] keys and is indicated at the bottom of the HUD under the azimuth coverage bar. The elevation coverage of the radar scan pattern is calculated from this parameter. Win10 i7-10700KF 32GB RTX3060 Rift S T16000M TWCS TFRP FC3 F-14A/B F-15E CA SC NTTR PG Syria Link to comment Share on other sites More sharing options...
BlackPixxel Posted October 7, 2019 Share Posted October 7, 2019 It is used in combination with scanzone up/down to set up the radar for a known target. If you for example know that a bandit is flying 20 km in front of you with an altitute of 3 km less than yours, then you would set the value in the bottom of the hud (distance to target) to 20, and the value in the right of the HUD (scanzone up/down) to -3. This will set up the radar in such a way that a target in a distance of 20 km in front of you with an altitute 3 km lower than yours will be in the center of the radar cone. Link to comment Share on other sites More sharing options...
Recommended Posts