rge75 Posted September 16, 2018 Share Posted September 16, 2018 I didn't fly the Ka-50 that often, so maybe I'm just doing something wrong (maybe blade angle too high and some damage)? It happened several times now to me that the Ka-50 suddenly starts losing altitude and no matter what I do, VSI won't recover. Either I'm really too stupid and I get into VRS with the Ka-50 or it's something else? I doubt it's VRS though because I still had enough speed - I must admit that I did not careafully check the airspeed though. My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 16, 2018 Share Posted September 16, 2018 The same here, but i cannot help you. Works your Autopilot? Seems there is somesthing strange or wrong with this KA-50. I heard they will give the KA-50 a new modern Skin and cockpit model for the new map engines, but i cannot tell if thats the Problems we have. Link to comment Share on other sites More sharing options...
rge75 Posted September 16, 2018 Author Share Posted September 16, 2018 (edited) Well, "Route" worked fine for me (most of the times). However, you I also tried to fly with Flight Director Mode because I sometimes prefer to fly the Ka-50 myself instead of just letting the Ka-50 flyining "itself". It happened with both modes though. Edited September 16, 2018 by rge75 My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 17, 2018 Share Posted September 17, 2018 (edited) Ok, but without trim is a self route fly not so nice, at me the rudder trim works not with KA-50. The FD Mode i need seldom cause Route Mode is ok in other missions, here it works not cause i cannot trimm well. But i have completly set DCS fresh new install at my PC with Windows 10 too. Maybe there was a Problem in software, hope so and will try it later again. Edited September 17, 2018 by Gerd-Wiem Link to comment Share on other sites More sharing options...
rge75 Posted September 17, 2018 Author Share Posted September 17, 2018 Unfortunately, I can't help you with this problem (my pedals stay in position, therefore I don't need trim). However, I think the Ka-50 doesn't need a lot of pedal input. It's flying pretty straight due to the two rotor blades. I hope you'll get it sorted out. Isn't there a checkbox in the "special options" which allows you to use trim on the pedals? At least that's how I remember it with the Huey. My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 19, 2018 Share Posted September 19, 2018 @rge75 Seems the Campaign is fixed. The Abris and Ekran in english and ruddder trim works now. I fly the 4. Mission today again. Link to comment Share on other sites More sharing options...
rge75 Posted September 19, 2018 Author Share Posted September 19, 2018 Thanks for the info....and does the Ka-50 not suddenly lose RPM and altitude anymore? Let me know if you managed to finish the mission. I may retry as well in a couple of days. My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 20, 2018 Share Posted September 20, 2018 (edited) Sorry, but in Mission 4 was after DCS Restart again Abris and Takran in english and no Rudder Trim, but i finished it without RTB. Thought RTB is not necessary like Provider told (like Arcade), got only 60 percent. The suddenly loss of power i had there not, but the other Problems i told. Than Mission 5, there Abris, Takran and Rudder Trim is work well there and it was very heavy for me. With full load and over 2500m a gras farp start an very close Targets in the hills, between mountains and trees. Abris Target Points done and on. Maximal Combat Weight about 11300 kg. You Need a full open throttle there. A nice Mission, hope i told not to much..Mission 5 complete. This Mission was very nice but not easy to me. Edited September 20, 2018 by Gerd-Wiem Link to comment Share on other sites More sharing options...
rge75 Posted September 20, 2018 Author Share Posted September 20, 2018 Well, I tried again and even though I finished it this time (with 100 score), I had some issues. - On the 2nd target, I've got the message "enough, get back" after firing some rockets and getting close to it - when I returned and landed on the ship again, I received the message "Rockets missed the target. Eagle, get back to the point" followed by the message "Mission Failed" and "Mission completed". In other words, there are still some strange/wrong triggers. I guess it's by design, that you lose more and more instruments because it's still a "new" helicopter and because it's a test flight. However, I again got the RPM warning, but at least this time right before I was landing. I wonder if this failure is also triggered after a specific time? So maybe I flew faster this time and therefor manged to get back. I really don't know. Also, the Ebris often told me something like Obleden Vkljutschi pos vint My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 21, 2018 Share Posted September 21, 2018 "Mission Failed" and "Mission completed". Same in other missions here, but i ignored it and after all Targets deleted, Mission complete. Do you mean Mission 4, there i cannot land cause absent rudder trim. Seems strange Bugs through the whole camapingn.. or single missions are build to a whole Campaign. Link to comment Share on other sites More sharing options...
rge75 Posted September 21, 2018 Author Share Posted September 21, 2018 Yes, it was in mission 4. My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
STONE SKY Posted September 22, 2018 Share Posted September 22, 2018 Well, I tried again and even though I finished it this time (with 100 score), I had some issues. - On the 2nd target, I've got the message "enough, get back" after firing some rockets and getting close to it - when I returned and landed on the ship again, I received the message "Rockets missed the target. Eagle, get back to the point" followed by the message "Mission Failed" and "Mission completed". In other words, there are still some strange/wrong triggers. I guess it's by design, that you lose more and more instruments because it's still a "new" helicopter and because it's a test flight. However, I again got the RPM warning, but at least this time right before I was landing. I wonder if this failure is also triggered after a specific time? So maybe I flew faster this time and therefor manged to get back. I really don't know. Also, the Ebris often told me something like Obleden Vkljutschi pos vint 1. Mission failed and mission completed. It seems triggers work incorrectly there. Looks exactly like this. Perhaps, you've launched rockets during the attack on the first target and missed. Perhaps, rockets have hit he target, but didn't deal damage to the first target. The phrase "Rockets missed the target. Eagle, get back to the point", shows up if you don't hit the target. It's hard to say why they have triggered at the end. It may be like: you did everything right, landed the heli but damaged it at the moment when the "mission completed" has already triggered. During the test, i often had a situation when along with the death or damage to the heli some unrealted triggers have functioned. Altough i did my est to relate them to different conditions 2. i didn't build in any mechanical misfunctions. But according to stats you have described, that is: - obleden - rotor icing - vkljutschi - turn on the tumbler on the upper panel pos vint. it's a serious accident during the cold weather which may lead to a dip (altitue loss). Support https://forum.dcs.world/forum/323-stone-sky/ Support Discord https://discord.com/invite/vtySPKuERg Support Facebook https://www.facebook.com/stone1sky Support youtube https://www.youtube.com/channel/UC8Q..._as=subscriber Link to comment Share on other sites More sharing options...
rge75 Posted September 22, 2018 Author Share Posted September 22, 2018 Thanks for the reply. As far as I remember, I shot one guided rocket onto the first target, but I also think I was told to "go on". That's why I did not fire a 2nd rocket. So yes, maybe the ship was not really damaged. Also, I indeed damaged the helicopter during landing because I lost altitude again. Since you said that obleden is rotor icing, this may be the issue. Due to the hotstart, I did not check if De-Ice was on or not. This could be the explanation why I always crashed. My DCS videos https://www.youtube.com/channel/UCJX2av4UE4xqWto3y8EZWMw [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
STONE SKY Posted September 23, 2018 Share Posted September 23, 2018 Happy to help Support https://forum.dcs.world/forum/323-stone-sky/ Support Discord https://discord.com/invite/vtySPKuERg Support Facebook https://www.facebook.com/stone1sky Support youtube https://www.youtube.com/channel/UC8Q..._as=subscriber Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 23, 2018 Share Posted September 23, 2018 (edited) Forexkor, i now at Mission 9 but have Problems to find my Targets. During the Auto Route and searching through TV, or target screen with Shkval on to points i looked in F-10 map and suddenly i was outside my heli, meant F-1 works no more. But is of course not a Campaign Problem i sure, a DCS problem. Mission 8 was heavy again but nice to me, the land on Bridge with Auto Hover too. Mission complete. And the Bugs are much more seldom now, like in Mission 7 a return to dcs during end of Mission just bevore Landing (60 percent again), but i went on in campaign and it could be a PC Problem here at me. All the same, a nice but heavy interesting Campaign, something other like the whole gameplay and you should have to fly your birds perfectly like the Ka-50 as special. Only the Sound i switch in helis off cause it disturbs my concentration. It is seldom to have in a beta Software like DCS since years a bugfree Campaign. Greetings. Gerd Edited September 23, 2018 by Gerd-Wiem Link to comment Share on other sites More sharing options...
Gerd-Wiem Posted September 23, 2018 Share Posted September 23, 2018 Back to Mission 5, in a real world conflict a Pilot will be cut of the Radio in a stress Situation during an attack run, special when he is under fire attack. Therfore it is not always possible to earn a 100 percent success like in a Gameplay, but it is of Course here possible. Because of that i ignored it in Mission 5, but got all points after deleted the targets, in other missions not the whole 100 percent. Link to comment Share on other sites More sharing options...
STONE SKY Posted September 24, 2018 Share Posted September 24, 2018 Back to Mission 5, in a real world conflict a Pilot will be cut of the Radio in a stress Situation during an attack run, special when he is under fire attack. Therfore it is not always possible to earn a 100 percent success like in a Gameplay, but it is of Course here possible. Because of that i ignored it in Mission 5, but got all points after deleted the targets, in other missions not the whole 100 percent. it's great to hear your review about the campaign and tips as well. Thank you, will do our best! Support https://forum.dcs.world/forum/323-stone-sky/ Support Discord https://discord.com/invite/vtySPKuERg Support Facebook https://www.facebook.com/stone1sky Support youtube https://www.youtube.com/channel/UC8Q..._as=subscriber Link to comment Share on other sites More sharing options...
TheNicePig Posted July 24, 2020 Share Posted July 24, 2020 (edited) Mission 4: "Sea Wolf" - Ka-50 Special Settings not applied? [Deleted] Edited July 24, 2020 by TheNicePig Wrong place. Link to comment Share on other sites More sharing options...
Recommended Posts