Hawss Posted March 8, 2016 Share Posted March 8, 2016 Just started getting into DCS Bios with the acquisition of an Arduino Uno. The User Guide makes reference to using TemplateSketch to kick off your first and most basic interface between your Arduino and DCS, but this did now come with the DCS Bios library that I just downloaded. Can I just use the Master Caution panel example or one of the others to begin? Appreciate the help... :) Link to comment Share on other sites More sharing options...
BravoYankee4 Posted March 8, 2016 Share Posted March 8, 2016 Just started getting into DCS Bios with the acquisition of an Arduino Uno. The User Guide makes reference to using TemplateSketch to kick off your first and most basic interface between your Arduino and DCS, but this did now come with the DCS Bios library that I just downloaded. Can I just use the Master Caution panel example or one of the others to begin? Appreciate the help... :) Isn't the Master Caution sketch the template referred to? Link to comment Share on other sites More sharing options...
FSFIan Posted March 8, 2016 Share Posted March 8, 2016 Sorry, that was an oversight on my part; I forgot to change that part of the documentation. Use the IRQSerial sketch as a template. If that does not compile (because you are using some Arduino board that doesn't have a ATMega328 or ATMega2560), use DefaultSerial instead. DCS-BIOS | How to export CMSP, RWR, etc. through MonitorSetup.lua Link to comment Share on other sites More sharing options...
Hawss Posted March 9, 2016 Author Share Posted March 9, 2016 Thanks much, the IRQSerial sketch works well as the template. I got the first few switches and LED's working flawlessly. Link to comment Share on other sites More sharing options...
Wiscodin Posted March 10, 2017 Share Posted March 10, 2017 Dear Ian, From reading several posts on here you seem to be very knowledgeable about arduinoand DCS bios. I am very new to Arduino and DCS bios, I've built a 3D cockpit sim for the Bell UH-1H module in DCS. However several of the rotary switch is particularly on many of the different radios have only a preset increase or decrease function in the module so I'm wanting to use the Arduino language to make them work properly using either rotary switches or rotary encoders. I have the Arduino card and DCS bios, the DCS bios library for Arduino etc. and I'm learning how to use them. But whenever I try to test Simple button or switch in DCS nothing happens. The switch is wired correctly that much I'm sure of because I do a lot of electrical work on the side and I follow the instructions in the DCS bios user guide. My problem is I don't know how to get DCS software script to communicate with DCS bios/arduino script. can you help me out? Thanks Link to comment Share on other sites More sharing options...
Recommended Posts