Set failure bug

Hello! Looks like when a failure is set via trigger, the next time the failure will activate even if the trigger conditions are not met. See the thread and test mission here:

https://forums.eagle.ru/showthread.php?p=4034352#post4034352

I thought it was a DCS bug, but Rudel made me realize it was only the F-14.

Seems to me like a bug of the F-14 module rather than the trigger .. the first time that I run the mission it works as intended.

 

Once I've used the F10 command and induced the Hydraulic Failure, then if I wait until the aircraft loses electric power, then F-14 module seems to not clear-up its status, so if I restart the mission it will have the Failure already ON, even if I return to the Editor and then run the mission again, the Failure is still ON.

 

If I restart the mission before the aircraft loses power, then the above situation doesn't occur and I can fly fine until I induce the failure with the F10 option.

 

If I close DCS and start it again, then the Failure will have cleared and the mission will run fine.

Could this be related to and the cause of the bug where the right engine does not spin up after re-spawning form being shot down??

https://forums.eagle.ru/showthread.php?t=235738

Yeah, maybe. Looks like some failures get carried over to the next mission, set by trigger or inflicted in combat.

Any words please? I know you guys are working your fingers to the bone, I just want to know if it's on your list. Thanks!

Yes HB. Any news?

Sent from my iPhone using Tapatalk