Hornetjock Posted September 5, 2019 Share Posted September 5, 2019 I have downloaded a fresh copy of CH Control Manager and am running Win 10 64 bit. The throttle is stuck at 30% and will not close to idle on ALL aircraft in the sim. Whereas before I could get to the calibrate button (I deleted the previous version of CH Manager when the problem arose) now I cannot get it into Mapped/Direct modes nor calibrate. Looks like a conflict between Win 10 and CH. Anyone else strike this weird problem? Link to comment Share on other sites More sharing options...
Griffin Posted September 20, 2019 Share Posted September 20, 2019 CH Control Manager should work on Windows 10 if you download it from here: http://www.chproducts.com/13-29170-Downloads-and-Community.php.html Most importantly, follow the instructions of the second post in this thread: https://forum.il2sturmovik.com/topic/33087-enabling-ch-products-joystick-control-manager-in-windows-10/ This should allow you to get into mapped/direct modes providing that you start the Control Manager immediately after boot. After a couple of minutes they stop working if you don't. Link to comment Share on other sites More sharing options...
Jodet Posted September 21, 2019 Share Posted September 21, 2019 CH Control Manager should work on Windows 10 if you download it from here: http://www.chproducts.com/13-29170-Downloads-and-Community.php.html Most importantly, follow the instructions of the second post in this thread: https://forum.il2sturmovik.com/topic/33087-enabling-ch-products-joystick-control-manager-in-windows-10/ This should allow you to get into mapped/direct modes providing that you start the Control Manager immediately after boot. After a couple of minutes they stop working if you don't. I've had good luck with the 'download your map as soon as you start your PC' but then after awhile my controllers will randomly not be found. Last time it was the rudder pedals that vanished. I've tried all the tricks I've read online, nothing works consistently. Link to comment Share on other sites More sharing options...
Svsmokey Posted September 21, 2019 Share Posted September 21, 2019 Imo , forget Control Manager . While the controllers are great , the software is inadequately supported . I use CM only for calibration , and make my bindings directly in DCS . If you can't access CM calibration , try Windows controller menu . I have had no problems to date using it with CH . 9700k @ stock , Aorus Pro Z390 wifi , 32gb 3200 mhz CL16 , 1tb EVO 970 , MSI RX 6800XT Gaming X TRIO , Seasonic Prime 850w Gold , Coolermaster H500m , Noctua NH-D15S , CH Pro throttle and T50CM2/WarBrD base on Foxxmounts , CH pedals , Reverb G2v2 Link to comment Share on other sites More sharing options...
Recommended Posts