Jump to content

Trim control problems


Recommended Posts

I'm having trouble with the trim control on my Thrustmaster Warthog FCS. I can't get the trim just right in DCS F-5. Either it's too much or too little. Does anyone have the Warthog and experienced this problem?

AMD A10-7870K Radeon R7, 12 Core Processor 3.90 GHz.

16 GB of Ram

2 MSI Armor Radeon RX580 8GB Graphics Cards

LG Blue Ray

Samsung 1TB SSD

Western Digital 1TB HD

2TB Western Digital SSD

Corsair Full Tower

Liquid Cooling

Windows 10 Professional 64 Bit

27 Samsung LED curved Monitor

Link to comment
Share on other sites

Not really. It takes a combo of trim and power to achieve what you desire just like in a real aircraft.

Asus ROG C6H | AMD Ryzen 3600 @ 4.2Ghz | Gigabyte Aorus Waterforce WB 1080ti | 32Gb Crucial DDR4/3600 | 2Tb Intel NVMe drive | Samsung Odyssey+ VR | Thrustmaster Warthog | Saitek pedals | Custom geothermal cooling loop with a homemade 40' copper heat exchanger 35' in the ground

Link to comment
Share on other sites

I'm a real-world pilot of 35 years. Iknow that. I'm having trouble with my Warthog & trim control.

AMD A10-7870K Radeon R7, 12 Core Processor 3.90 GHz.

16 GB of Ram

2 MSI Armor Radeon RX580 8GB Graphics Cards

LG Blue Ray

Samsung 1TB SSD

Western Digital 1TB HD

2TB Western Digital SSD

Corsair Full Tower

Liquid Cooling

Windows 10 Professional 64 Bit

27 Samsung LED curved Monitor

Link to comment
Share on other sites

I dont have the F-5, so I cant replicate. From your description the DCS trim steps are too large?

 

The Target Script command "TrimDXAxis" is probably your friend here, you can set trim outside of DCS to whatever granular value you like.

Link to comment
Share on other sites

Both

AMD A10-7870K Radeon R7, 12 Core Processor 3.90 GHz.

16 GB of Ram

2 MSI Armor Radeon RX580 8GB Graphics Cards

LG Blue Ray

Samsung 1TB SSD

Western Digital 1TB HD

2TB Western Digital SSD

Corsair Full Tower

Liquid Cooling

Windows 10 Professional 64 Bit

27 Samsung LED curved Monitor

Link to comment
Share on other sites

I had problems with my roll trim being too coarse, so i changed to trim the X axis of my WH in target script editor.

Pitch trim ingame is fine, most of the times it will trim to handsfree.

Make sure you have all deadzones turned off, including the hardware deadzone in target GUI, and have a small curve on your Y axis. That way small stick corrections is easier, and trim less of a problem.

 

Is it way off for you, or just a little?

[sIGPIC][/sIGPIC]

Win10 64, Asus Maximus VIII Formula, i5 6600K, Geforce 980 GTX Ti, 32 GB Ram, Samsung EVO SSD.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...