CASE 1 Chart

I know that one of these has already been done, I just wanted to do one that was a little more art driven

Suggestions for changes appreciated,

I added one that is more printer friendly.

 

I know that one of these has already been done, I just wanted to do one that was a little more art driven

 

Suggestions for changes appreciated,

Nice job, thanks! This will help while practicing!

Gesendet von iPhone mit Tapatalk

Just some notes in inaccuracies

1. Marshal Stack starts at 2000'
   
2. 600' AGL should be reached by the start of the approach turn
   
3. Hook should be lowered before entering the recovery pattern (3nm DME), not on downwind
   
4. Groove is 15-18 seconds
   
5. Touch and Go Bolter should be fly dirty on BRC to 600' 30 deg aob at interval (meaning if others are in the pattern, make sure you are in interval with them)
   

What is the correct rule here when starting the break?

Can you start your descent when going into the break and spiral down to 600 for the downwind, or are you meant to hold 800 until leveling off, then drop down to 600. I generally just spiral down.

The correct way is to do a level break and then once on downwind, descend to 600'

The correct way is to do a level break and then once on downwind, descend to 600'

Thanks MooneyTail

I've been keeping fairly level to the 90 degree drop gear spot, need more work on staying level for the next 90 degrees before the downwind.

Descending under G in the break is a good way to fly into the water.

For me it's around where you start dropping the gear and flaps, I tend to let it slowly fall below the 800 mark towards the 600 to early. The break is just getting that steep bank angle right for the pull.

You are technically suppose to level break then stay at 800' till you are on speed, then descend. I imagine in practice once you get good you can do it all at the same time.