HOTAS enable switch for AGM modes

Cursor/Enable switch on the throttle should iterate the AGM-65 pre/vis/bore modes.

It does, as long as you have the WPN page as SOI.

That's a bug, enable switch should change EO mode regardless of SOI. All that is required is AGM-65 selected.

Enable Switch not cycling EO submodes when WPN not SOI

The enable switch should cycle EO submodes (PRE VIS BORE) whenever AGM-65 is selected. Currently this function is only changing modes when AGM-65 is selected and WPN format is SOI.

F16 EO enable WPN SOI.trk

Even if WPN page is SOI, the iteration gets stuck after max 3 presses.

i can't get it to switch more than 1 mode. if it's on PRE and i press the button, it goes to VIS and stays there, no matter what i try.

After the 04.Nov 2020 update it still get's stuck after a number presses.

It gets stuck because SOI moves away from the WPN format automatically in one of the modes. This is fine except DCS incorrectly requires WPN format to be SOI for enable switch to function. In the real airplane the SOI would change automatically with the cycling modes and enable would continue to function regardless of SOI.