Cskelly Posted September 16, 2017 Share Posted September 16, 2017 I can not complete mission 10 the frame rate drop to 3 -7. I have changed settings to lowest possible. Did DCS world repair. updated drivers. I have been working for days with no luck. Anyone else have this problem? I am not much of a computer guru, just love flight sims. I sent a request to support, but thought I would check here also. I flew the first mission with F-15 Georgian War, my FPS were about 60-80 on the ground, and 180-200 in the air. A10 Georgian Hammer seems to be doing fine. All on medium to high settings. Thanks in advance! system specs Intel® Core i7-3820 CPU @ 3.60GHz, Win 7 64, Radeon R9 390 8192mb, 20mb RAM Link to comment Share on other sites More sharing options...
Ramsay Posted September 17, 2017 Share Posted September 17, 2017 (edited) I can not complete mission 10 the frame rate drop to 3 -7. ... Anyone else have this problem? Yes, I attributed it to the single thread performance and base clock of my older i7 860 @2.8GHz CPU, sort of glad I'm not the only one. I am a little surprised though, as your system specs are better than mine System Specs i7 860 @2.8GHz , 12GB DDR3 , GTX670 2GB, 2+4TB HD, MSFFB2 joystick, X52 Pro Thottle, TIR5, Win 10 Pro x64, 1920X1080 Edited September 17, 2017 by Ramsay i9 9900K @4.7GHz, 64GB DDR4, RTX4070 12GB, 1+2TB NVMe, 6+4TB HD, 4+1TB SSD, Winwing Orion 2 F-15EX Throttle + F-16EX Stick, TPR Pedals, TIR5, Win 10 Pro x64, 1920X1080 Link to comment Share on other sites More sharing options...
dimitriov Posted September 17, 2017 Share Posted September 17, 2017 Hi, Waiting to get the new version to come with next DCS major update, as long as some major issues have appeared on this one. It would be pointless to release a fix for this only right now, as long as I may have to rework the entire mission. Once next major update is released and that I have the new files, I will make some tuning. Don't worry about your computer, it's simply that I put a bit too many AI units, and in 2015, it still used to run smoothly with GTX-970/I-7 3820/16 Go RAM in ultra settings... In 4K. But it seems that DCS optimization is currently quite bad. So pause the campaign until there is a fix, really sorry about this, so much work on it and then DCS simply destroys everything ^^ Nicolas Link to comment Share on other sites More sharing options...
Cskelly Posted September 17, 2017 Author Share Posted September 17, 2017 Okay thanks for the info! Link to comment Share on other sites More sharing options...
Patersonski Posted October 11, 2017 Share Posted October 11, 2017 I can not complete mission 10 the frame rate drop to 3 -7. I have changed settings to lowest possible. Did DCS world repair. updated drivers. I have been working for days with no luck. Anyone else have this problem? I am not much of a computer guru, just love flight sims. I sent a request to support, but thought I would check here also. I flew the first mission with F-15 Georgian War, my FPS were about 60-80 on the ground, and 180-200 in the air. A10 Georgian Hammer seems to be doing fine. All on medium to high settings. Thanks in advance! system specs Intel® Core i7-3820 CPU @ 3.60GHz, Win 7 64, Radeon R9 390 8192mb, 20mb RAMI completed Dixmude recently and found the same thing - 2 or 3 missions where you're flying towards a FARP with a lot of objects and the frames drop into the single digits. This sounds dumb but my solution was to 'not look at it'. Don't fly direct to a busy FARP, but to a point near it so that all the objects are not on your screen on approach, then pivot over at the end. Also, when you're landing, face the side of the FARP with the fewest objects (least bad frames). I don't remember this issue cropping up after mission 10 so if you can get through this one you'll probably be OK. Sent from my ASUS_Z01FD using Tapatalk Rig: i7-6850K, Sapphire 6900XT, 32GB RAM, Asus X99-Pro board. Gear: VPC WarBRD/MongoosT-50 Stick, VPC MongoosMT-50 Throttle, VKB T-Rudders Mk.IV Pedals, HP Reverb G2. Link to comment Share on other sites More sharing options...
Ramsay Posted October 12, 2017 Share Posted October 12, 2017 (edited) But it seems that DCS optimization is currently quite bad. I don't remember this issue cropping up after mission 10 so if you can get through this one you'll probably be OK. Mission 10's frame-rate has greatly improved to 20-40 FPS with the optimisations in DCS 1.5.7.10175, there are still dips but the mission is actually playable (for me) for the first time since I bought the Gazelle. Note: The mission it's self hasn't been changed/reworked - the FPS improvement is purely due to changes within DCS and/or the module. "Good job and well done" :thumbup: to whom ever was responsible. YMMV Edited October 12, 2017 by Ramsay i9 9900K @4.7GHz, 64GB DDR4, RTX4070 12GB, 1+2TB NVMe, 6+4TB HD, 4+1TB SSD, Winwing Orion 2 F-15EX Throttle + F-16EX Stick, TPR Pedals, TIR5, Win 10 Pro x64, 1920X1080 Link to comment Share on other sites More sharing options...
dimitriov Posted October 13, 2017 Share Posted October 13, 2017 To confirm by other people then. You should soon get an update to fix the various "Meatboy/Sluggy doesn't take off or land on my face". At least files have been given. Nicolas Link to comment Share on other sites More sharing options...
Cskelly Posted October 21, 2017 Author Share Posted October 21, 2017 Still no joy on mission 10. Getting on average 1-3 fps, max 9. The only thing I am worried about will I need a new rig for the up coming modules, like the F-18? I would really love to see the campaign through though. I guess I will keep checking after each update. Thanks system specs Intel® Core i7-3820 CPU @ 3.60GHz, Win 7 64, Radeon R9 390 8192mb, 20mb RAM Link to comment Share on other sites More sharing options...
Recommended Posts