FoxTrotAlpha691 Posted February 20, 2020 Share Posted February 20, 2020 Good day, I have been working with using the HA submode of DGFT mode and can only enter this mode of the RADAR is in the center MFCD. This mode is not available if the radar is on the Left or Right MFCD, is this normal behavior for this submode? I have attached the game track and the DCS log file, any information is appreciated.DGFT_HUD_MODE_TEST.trkHUD TEST.zip Link to comment Share on other sites More sharing options...
foxwxl Posted February 20, 2020 Share Posted February 20, 2020 I found the problem is related with RDR PAGE SOI, if you go to ACM set the MFD page as your like, and then enter INTC mode set the RDR page on same MFD that you just set in ACM, and switch SOI to that MFD. And now entering ACM mode, you should freely switch to any ACM mode you want. Deka Ironwork Tester Team Link to comment Share on other sites More sharing options...
FoxTrotAlpha691 Posted February 20, 2020 Author Share Posted February 20, 2020 I got it: Enter DGFT mode Setup RADAR on desired MFCD (*Left for me) Enter INTC mode Make that MFCD the SOI You can now enter HA mode from DGFT mode and back to INTC mode, it confused me when you were using ACM because that is the same as DGFT mode, a small misunderstanding but you still put me on track, salute! Link to comment Share on other sites More sharing options...
foxwxl Posted February 21, 2020 Share Posted February 21, 2020 I've reported this bug to the team, U should not needed to switch these stuff any more when the patch come out. Deka Ironwork Tester Team Link to comment Share on other sites More sharing options...
FoxTrotAlpha691 Posted February 21, 2020 Author Share Posted February 21, 2020 I've reported this bug to the team, U should not needed to switch these stuff any more when the patch come out. Excellent, thanks for the response this workaround will be ok until your team has time to fix it. Link to comment Share on other sites More sharing options...
Recommended Posts