fencible Posted March 13, 2019 Share Posted March 13, 2019 I can no longer cold start Huey. Gas converter reaches only about 1800 RPM and will not go beyond. If I run the Cold Start training mission, it works fine. Also if I run a hot start mission, and shut down the engine, then I can start it up ok. I have noticed that the control settings menu has a corruption: there are two entries for the External Cargo Safety switch. Link to comment Share on other sites More sharing options...
Elor Posted March 13, 2019 Share Posted March 13, 2019 I move the throttle to the max position and then back to idle after switching the fuel on and before pressing the starter button. That should fix it. Link to comment Share on other sites More sharing options...
fencible Posted March 18, 2019 Author Share Posted March 18, 2019 I move the throttle to the max position and then back to idle after switching the fuel on and before pressing the starter button. That should fix it. Yes, this works! Thank you Elor. This throttle movement was not a requirement before, so something has recently changed, and my key-binding list is still corrupted. Link to comment Share on other sites More sharing options...
Elor Posted March 19, 2019 Share Posted March 19, 2019 Yes, this works! Thank you Elor. This throttle movement was not a requirement before, so something has recently changed, and my key-binding list is still corrupted. Welcome.:) Link to comment Share on other sites More sharing options...
jonsky7 Posted March 23, 2019 Share Posted March 23, 2019 Yes, this works! Thank you Elor. This throttle movement was not a requirement before, so something has recently changed, and my key-binding list is still corrupted. For corrupted keybinds, I believe this came about when ED added binding files for the most common joysticks/throttles. If you go to DCS WORLD/Mods/Aircraft/Uh-1H/input/UH-1H/joystick and move/delete all the files except default.lua, you're bindings should return to normal I suggest just moving the files out of the folder to check if it works first, you can always put them back in if needed. Link to comment Share on other sites More sharing options...
IJammer Posted January 13, 2021 Share Posted January 13, 2021 I am not sure if this is typical to all... I find that my binding for the Warthog left throttle arm for the Huey throttle does not bind correctly... so make sure that you can see the throttle rotate on the collective (on screen) before startup else the turbine will not increase RPM past idle! Use the KB keys 'page up / page down' to kick start the Warthog left throttle. Once done it then works ok after! Itried removing the KB binds incase this was interfering with the Warthog binding... but it didn't fix it! Link to comment Share on other sites More sharing options...
Recommended Posts