Jump to content

[General DCS LOD Bug] IR-Zoom does not show unit


Tiramisu

Recommended Posts

I am not sure, if this has been already reported, but as you can see here the dead manpad is not visible any more on max zoom-out-level. Probably it would also happen to alive units, but I have not tried that out yet:

 

 

Of course the unit becomes smaller when I zoom out, but he should still be visible, if this bug did not occure.

Link to comment
Share on other sites

Which version of DCS was this? At least the 2.5.6.43453 had serious issues with quite a few LODs (i.e. not a Gazelle problem, but a general DCS problem). Latest two hotfixes should have this problem remedied, though,

i9-9900K @ 5.1GHz | MSI Ventus 3X OC RTX3090 24GB | 64GB 3200MHz DDR4 | Asus ROG Strix Z390-E | Asus Xonar DGX 5.1 Sound Card | Virpil T50CM2 base w/ F/A-18C / A-10C / Virpil T50CM2 Grip | WinWing Super Taurus Throttle | MFG pedals | TekCreations Hornet UFC, Landing Panel, Right Console | WinWing Hornet Combat Ready Panel | Buddy Fox UFC | Foxx Mount | 3 x TM Cougar MFD | HP Reverb G2 | Wacom Intuos S (with VRK) | Honeycomb Alpha Yoke | Thrustmaster Warthog HOTAS | CH Fighter Stick Pro & Throttle | MS Sidewinder 2 FFB | Track IR 5 | Oculus Rift CV1

善く戦う者は、まず勝つべからざるを為して、以て敵の勝つべきを待つ。

Link to comment
Share on other sites

Hi there,

 

I just checked and it seems that it is a LOD issue on the dead manpad model. You can verify this yourself by placing that unit in the editor, have it killed and zoom out.

 

You'll notice the model will disappear at a certain (short) distance.

It'd be best to report this issue to ED as it is not Gazelle related. Good catch though!


Edited by Polychop Simulations

Community Manager Account



DrummerNL

[TABLE]

[/TABLE]

Discord - Facebook - Gazelle sitreps

[sIGPIC][/sIGPIC]

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...