Jump to content

OpenHornet F/A-18C 1:1 SimPit (WIP)


jrsteensen

Recommended Posts

2 hours ago, Fri13 said:

 

I assume that is the distance in this part?

 

image.png

 

As I am searching the distance between the front for scaling the 3D world in VR. By simply cutting correct size stick and then "feeling" the scale to visual.

 

image.png

 

 

I have seen that same 21" measurement elsewhere, but I assume it is through the whole seat position up to the front, outer edges of both DDI?

 

There is a step file with reference dimensions in the "reference" folder of the github, if you would like to check that out.

Link to comment
Share on other sites

21 minutes ago, jrsteensen said:

There is a step file with reference dimensions in the "reference" folder of the github, if you would like to check that out.

 

Thanks, now just need to find the GIT directory x)

i7-8700k, 32GB 2666Mhz DDR4, 2x 2080S SLI 8GB, Oculus Rift S.

i7-8700k, 16GB 2666Mhz DDR4, 1080Ti 11GB, 27" 4K, 65" HDR 4K.

Link to comment
Share on other sites

  • 2 years later...

Hey,

is this project still alive? 

I couldn´t open a single Step-file I could find on github. I´ve tried Fusion360, Freecad and StepViewer and received an error message.

Edit: I´ve found the Tutorial "Downloading & Importing OpenHornet Fusion360 Models" and will try it this way. Puh, it´s not easy for the start.


Edited by Icebear
  • Like 1
Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...