3Dmigoto VR mod for DCS : new zoom, label masking and Pimax Parallel Projection fix - Page 10 - ED Forums
 


Notices

Reply
 
Thread Tools Display Modes
Old 09-10-2019, 11:25 PM   #91
USA_Recon
Member
 
Join Date: Sep 2013
Posts: 249
Default

I am getting wierd artifacts when zooming in and moving my head - like a dark blue shadow - and the water looks odd
USA_Recon is offline   Reply With Quote
Old 09-10-2019, 11:32 PM   #92
USA_Recon
Member
 
Join Date: Sep 2013
Posts: 249
Default

How would I go around binding the page up to my TM stick ?
USA_Recon is offline   Reply With Quote
Old 09-11-2019, 04:51 AM   #93
majapahit
Senior Member
 
Join Date: Jul 2009
Posts: 1,268
Default

Quote:
Originally Posted by USA_Recon View Post
How would I go around binding the page up to my TM stick ?
which plane?
with FA18C there is problem with used keys
I use TARGET programming for own keys
f.i.

// VR ZOOM MOD 2x 5x 10x // F22 F23 F24 = 71 72 73
// MapKey(&Throttle,BSB,DX32);
MapKey(&Throttle,BSB,USB[0x73]); // BSB Boat back 5x

etc

learn TARGET
__________________
Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | Throttle Quadrants | 8600K | GTX 1080 | 32GB RAM| Win 10 x64 | Voicerecognition | 40" 1080p TV | 2x 24" 1080p side monitors | 24" 1080p touchscreen | VR googles
majapahit is offline   Reply With Quote
Old 09-11-2019, 06:27 AM   #94
majapahit
Senior Member
 
Join Date: Jul 2009
Posts: 1,268
Default

Quote:
Originally Posted by USA_Recon View Post
How would I go around binding the page up to my TM stick ?
Actually I just figured out the easiest way would be to install JoytoKey
https://joytokey.net/en/download
Its 7USD but I think the 'trial' never expires so just try and see.
Connect your USB joystick devices, configure how many there are in setup, each gets its own tab.
Push a button and it shows up in the tab/button/axis listing, assign key to button (can do a lot more), the same u define in 3dmigito *.ini, done
(I think, I'm using target, but this comes in handy with all my other devices that could use SHIFT buttons, which this program also can do)
__________________
Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | Throttle Quadrants | 8600K | GTX 1080 | 32GB RAM| Win 10 x64 | Voicerecognition | 40" 1080p TV | 2x 24" 1080p side monitors | 24" 1080p touchscreen | VR googles

Last edited by majapahit; 09-11-2019 at 12:22 PM.
majapahit is offline   Reply With Quote
Old 09-11-2019, 09:45 AM   #95
lefuneste01
Member
 
Join Date: Oct 2010
Location: france
Posts: 323
Default

Quote:
Originally Posted by USA_Recon View Post
I am getting wierd artifacts when zooming in and moving my head - like a dark blue shadow - and the water looks odd
could you post a track and check that you do not have "cockpit illumination" in your graphics settings ?
__________________
P8700K @4.8 GHz, 1080ti, 16 GB RAM, Pimax 5k+
I spend my time making 3dmigoto VR mods for BoS and DCS instead of flying, see https://www.patreon.com/lefuneste
lefuneste01 is offline   Reply With Quote
Old 09-12-2019, 12:28 PM   #96
majapahit
Senior Member
 
Join Date: Jul 2009
Posts: 1,268
Default

errr,
the copy message is now on top of the original message, when before it was 'floating' (somewhere in the middle)? Can't see new incoming messages.
Perhaps the copy should be underneath were the news ones appear, this red hue is now rather a hue layer on all text?
or am I missing something?
__________________
Autopilot panel | Headtracker | TM HOTAS | G920 HOTAS | Throttle Quadrants | 8600K | GTX 1080 | 32GB RAM| Win 10 x64 | Voicerecognition | 40" 1080p TV | 2x 24" 1080p side monitors | 24" 1080p touchscreen | VR googles
majapahit is offline   Reply With Quote
Old 09-12-2019, 01:25 PM   #97
lefuneste01
Member
 
Join Date: Oct 2010
Location: france
Posts: 323
Default

Quote:
Originally Posted by majapahit View Post
errr,
the copy message is now on top of the original message, when before it was 'floating' (somewhere in the middle)? Can't see new incoming messages.
Perhaps the copy should be underneath were the news ones appear, this red hue is now rather a hue layer on all text?
or am I missing something?
This is the "improved" copy / paste feature. I had some situation where information were not on Radio messages place but on lower right part. Moreover, it was very hard to setup convergence for the former method (at least with Pimax).
So now the whole screen is copyed, and displayed at the same place as the original one. SHIFT+F5 toggle on/off the display, and I put it in red in order to show that this mode is active.
I can put it below the original one, but then the map will hide the copied message. I'll have a look in order to avoid to hide new messages.
__________________
P8700K @4.8 GHz, 1080ti, 16 GB RAM, Pimax 5k+
I spend my time making 3dmigoto VR mods for BoS and DCS instead of flying, see https://www.patreon.com/lefuneste

Last edited by lefuneste01; 09-12-2019 at 01:38 PM.
lefuneste01 is offline   Reply With Quote
Old 09-12-2019, 02:00 PM   #98
ariyaner
Junior Member
 
Join Date: Feb 2016
Posts: 47
Default

hi


i use pimax 5k and with small fov all is fine
i tryed to rise my fov and adapt the zoom via end /pgup button

but after 30 mins i gave up on backed to small fov
if someone have some experience with adapting in higher fovs plz share


just a small sidemark

i played a mission in mig21 with very bad weather (dynamic) and had some artefacts
ariyaner is offline   Reply With Quote
Old 09-12-2019, 02:53 PM   #99
wju
Junior Member
 
Join Date: Apr 2018
Location: Czechia, EU
Posts: 31
Default black screen at smoky area

lefuneste,
first of all, thanks for your work, especially the zoom is simply fantastic!

Unfortunately, I have experienced black flickering when flying by burning area, even without zoom.
First fly-by, when no target burning, everything is ok; starting at second attack, when some targets are already burning, whole screen black flickering appears and was getting worse with more targets exploding and burning.
The effect is repeatable by replaying trk file, when uninstalling 3Dmigoto VR mod flickering disappears, when reinstalling mod, appears again; both monitor and VR.

At least on my computer.

*.trk file and screenshots with setting attached


PS: Please don’t judge my combat skills
Attached Thumbnails
Click image for larger version

Name:	DCS set system.jpg
Views:	16
Size:	291.6 KB
ID:	217099   Click image for larger version

Name:	DCS set gameplay.jpg
Views:	10
Size:	272.3 KB
ID:	217100   Click image for larger version

Name:	DCS set misc.jpg
Views:	10
Size:	277.3 KB
ID:	217101  

Attached Files
File Type: trk Black Flickering.trk (4.30 MB, 2 views)

Last edited by wju; 09-12-2019 at 07:38 PM.
wju is offline   Reply With Quote
Old 09-13-2019, 06:00 PM   #100
lefuneste01
Member
 
Join Date: Oct 2010
Location: france
Posts: 323
Default

Quote:
Originally Posted by wju View Post
lefuneste,
first of all, thanks for your work, especially the zoom is simply fantastic!

Unfortunately, I have experienced black flickering when flying by burning area, even without zoom.
First fly-by, when no target burning, everything is ok; starting at second attack, when some targets are already burning, whole screen black flickering appears and was getting worse with more targets exploding and burning.
The effect is repeatable by replaying trk file, when uninstalling 3Dmigoto VR mod flickering disappears, when reinstalling mod, appears again; both monitor and VR.

At least on my computer.

*.trk file and screenshots with setting attached


PS: Please don’t judge my combat skills

Ok thanks to the track I found the fautly shader but for the moment I do not understand the problem...workaround = disable MSAA...
__________________
P8700K @4.8 GHz, 1080ti, 16 GB RAM, Pimax 5k+
I spend my time making 3dmigoto VR mods for BoS and DCS instead of flying, see https://www.patreon.com/lefuneste
lefuneste01 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 10:51 AM. vBulletin Skin by ForumMonkeys. Powered by vBulletin®.
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.