Flagrum Posted July 22, 2018 Share Posted July 22, 2018 Seen a few videos about how to set up the bomblet release altitude for the CBUs - from Wags and others - but for me it does not work as I understand it should work. I select RET at the SMS page, select MFUZ and use HT to set my desired release altitude. Then pickle ... and F6-watch the canister to desintegrate at about 1500 ft. Every time, no matter which HT alt I had choosen - 300 ft ... 1200 ft ... 3000 ft. Same result every time. See also the attached tacview file and examine the AGL of the canisters - they all end up at precisely 1500 ft (2 x 300 ft, 2 x 1200 ft, 1 x 3000 ft).Tacview-20180720-204822-DCS-ap1.trk.zip.acmi.zip Link to comment Share on other sites More sharing options...
Eldur Posted July 22, 2018 Share Posted July 22, 2018 I suspect it's just not in yet. "Let's set it to 1500' for now." I see what you did there, Wags Couldn't ge them to pop open at other altitudes as well, didn't check it with Tacview though, but watching the impact areas alone tells it already since the spread is always in the same ballpark. Link to comment Share on other sites More sharing options...
Recommended Posts