Jump to content

lantirn mod


joojoo

Recommended Posts

Hello to all

 

I try to get familiar with the lantirn mod that allows pilot to use it. In the controls setup there is not a designation key as far as I know but only undesignate target. I suppose that there is another command instead of target designation. Could you help?

 

Thanx

Link to comment
Share on other sites

Trigger full action, or second detent....

Former USN Avionics Tech

VF-41 86-90, 93-95

VF-101 90-93

 

Heatblur Tomcat SME

 

I9-9900K | Gigabyte Z390 Aorus Ultra | 32GB DDR4 3200 | Samsung 970 EVO Plus NVMe | RTX 2070 Super | TM Throttle | VPC Warbird Base TM F-18 Stick

Link to comment
Share on other sites

You'll have to make a waypoint where the targets are and slave the pod to it with the QWP+/- switch on the LANTIRN control stick, then use full trigger action on a target to create a QDES waypoint.

REAPER 51 | Tholozor
VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/
Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/

Link to comment
Share on other sites

Also remember to go to area track so that it doesn't constantly move when you have found something you are looking for. After sorting the pod for laser code A2G mode I go to area track as soon as I start to search the target area to stabilize the pod else it constantly fights you.

 

Sent from my GM1915 using Tapatalk


Edited by WindyTX

I7 3930 4.2GHz ( Hyperthreading Off), GTX1080, 16 GB ddr3

Hotas Warthog Saiteck Combat Pedals HTC Vive, Oculus CV1.

 

GTX 1080 Has its uses

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...